Archive for February 2019

Be Ready for the Perfect Garage Door Right Here

If the garage door does not join, then the garage itself is no longer fully usable. For a long life and the durable comfortable use, the door should therefore be set correctly and regularly maintained and maintained.

Set garage door

The fact that the settings on the garage door must be readjusted, can be seen from the fact that the garage door opens only stiffly, even squeaking noises indicate that the mechanics at the gate is no longer running correctly. Which settings are possible and required depends on the type of door.

Adjust the swing gate

This door version opens via lateral lever arms with steel compensating springs with or without electric drive. In order for the gate to open and close easily, the springs must have a certain tension. If it is too high or too low, it causes problems when opening and closing. How the swing is set in each case, is to take the manufacturer’s information to the gate, as a mark for a correct voltage, the gate remains at half height in its position, without sagging or continue to open upwards. If a swinging gate is already getting old, then sometimes the exchange of peat-feathers can pay off. How long the springs last depends primarily on the opening frequency. The more often the swing door is activated per day, the sooner the springs have to be replaced. For the Garage door tune up this happens to be a very important factor.

Tip: Before the peat springs are readjusted, rollers and rails should be checked. Wear, damage or contamination can also affect the smooth operation of the door.

Tip: Find cheapest offers for garages , compare and save up to 30%.

Set sectional door

Sectional doors are much more difficult to readjust than overhead doors, and faulty spring tension can also interfere with smooth operation. For troubleshooting, the drive chain can be unhooked in electric gate drives. If the gate can be opened and closed well by hand, then the fault lies with the motor and not with the gate itself. Sectional doors are readjusted from the inside with the door closed. The springs are relaxed and then re-tensioned, corresponding markings support this process in many models. A well-adjusted sectional door will remain in any position.

Adjust rolling door

Springs are also used for roller shutters,incorrect tension is noticeable due to uneven rolling, stiff rolling or squeaking noises. Correctly adjusted, that is, with a uniform and corrects spring tension, is a roll-up door, when it automatically rolls up after opening up to half the opening height.

Tip: The operator of a garage is obliged to regularly check the gate system. Disturbances must be eliminated immediately; the operator can take over this part himself or turn on a specialist company. Especially for gates with electric drive, the second variant is often the faster and safer solution.

Clean the garage door and wait – this is how it works

A well-maintained garage door has a long life and works even after years still smoothly. The care and maintenance includes on the one hand the drive and opening elements, but also the door leaf itself. Once a year, maintenance of the door is recommended, then rails, peat springs, electric drive and garage lock should be checked for proper functioning. Depending on the material of the door leaf, this should also be checked regularly and cleaned and repainted if necessary.

The steel products will be replaced with oxidized metals

Maresia, resalga, sea spray are just a few names used to refer to seawater droplets carried by the wind in the coastal regions. As mineral salts are very soluble in water (especially sodium chloride), they end up being transported by these drops and deposited on buildings, automobiles and appliances, where they cause corrosion of metal structures. It is now estimated that one fifth of all steel production in the world is destined to replace oxidized metals. The air conditioners, much used in coastal houses, are not left out. Read the text below and know some tips to protect your air conditioning from the sea air.

Use of aluminium tubes

The chemical composition of aluminium gives the metal greater resistance compared to copper, a material normally used in the construction of tubes. It also has the advantages of greater lightness, malleability and stability. Since most of the raw material used is recycled, tubes made of aluminium have a lower cost. At the time the tubes are changed, some care is needed. Parts such as the flange, bender springs and Hatcher should be cleaned. By leaving residual dust, copper can cause long term damage to aluminium. Carry out the cleaning and installation operation using suitable equipment and make sure that the material can be easily folded back to its original position due to its lower “spring” effect. In order to know more about Air conditioning repairs Geelong, one can always seek help from the web portals.

Outdoor Unit Coating

The damage does not only affect the internal part of the air conditioner. Even though it has an external structure designed for various types of climate, external units are not immune to the effects of the sea air. The use of external coatings can help protect the structure of the device from day to day. There are protectors made of various materials. The fibreglass has air vents, colour variation and differentiated sizes. They can protect and drain the rainwater through the condensation duct, avoid approaching small animals and help maintain the hygiene of the appliance. Because it is a light, malleable and resistant material, fibber can withstand the pressures of the coastal environment without interfering with the aesthetics of the place. Concrete protections and those made with a “roof” shape are less recommended for those looking to protect themselves from the sea. They have more complicated maintenance and cause discomfort on rainy days. A good coating will protect the unit from UVA and UVB rays and delay the effect of corrosion without affecting the ventilation and heat exchange parts.

Cleaning and constant maintenance

The cheapest way to rid your machine of the effects of corrosion is still preventive maintenance and constant cleaning. A condenser with dirt in the coils can increase energy consumption by up to 30%. When in doubt, look in your air conditioning manual for specific cleaning guidelines for your device. In general, streamers should be washed with mild detergent and running water. The fins and pipes of the coils should receive special care so that they are free of dirt embedded in their surfaces.

Look for a company that specializes in maintenance of air conditioners to perform the cleaning of the external unit. Regardless of how often you use the air conditioner, make sure your parts are clean and, if not, perform preventive maintenance preferably in the winter. This is essential to ensure the longer life of the device. In addition, the air coming from a well maintained appliance does not harm your health and that of your family.

  • Partner links